![]() On the below diagram it is however Reset and Kill. The two buttons are labeled on the board as RST and Play. Are these seperate lines, or can I use either of these? What is the max power that can run through these pins (VM and air assist)?ĭC V-in is stenciled as max 36V, however the DC in jack is labeled as max 24v. The board interfaces with a front panel which is used to set the laser power from 0 to 99.9. The white connector on the right is for the end stops (GND, YL, XL, GND and NC). This is no problem, but then it requires an extra SSR inbetween. The above M2-Nano board picture shows on the bottom the two stepper motor cables plus the connection to the laser power supply (blue: LO (Laser Out), 5V, GND and 24V input. We have an electronic valve that opens with 24v, but I cannot find if the VM+ / - is a continues powersource, or switched on/off with laser power just like the 5V air assist. What I am looking for is more detailed information on wiring, amps and pinout for several scenarios:Ĭompressed air is run throughout the building. When I received the board I noticed there it not an awefull lot of detailed technical information on the board nor attached / found online. While we are engineering the full machine, I already bought the Cohesion3D board to start prototyping and configuring. Cohesion3D Laserboardįirmware: Whatever it came with. ![]()
0 Comments
Leave a Reply. |